Table of Contents
Advertisement
User's Manual
Highlight the box beside Remote Watch – Quality and press the
the Quality from: Very High, High, Standard and Basic. Press the
NOTE: The higher Quality settings require higher Transfer Speed settings. The transfer
speed you set is the maximum speed. Depending on the network environment, this speed
may not be achieved.
You can limit the network bandwidth settings so that system does not consume too much network
bandwidth. Highlight the box beside Network Bandwidth Limit and press the Up and Down
arrow buttons to set the desired maximum bandwidth from 10Kbps to 100Mbps.
NOTE: When limiting the network bandwidth, the remote watch image on the PC running
RAS or WebGuard might not be displayed properly.
Highlight Enable SSL for Transferring Data and press the
Off. When it is On, the security of data except video transmitted for remote monitoring or remote
recording can be enhanced by using the SSL (Secure Sockets Layer) authentication. When using
the SSL function, the DVR cannot be connected with a remote program or a network keyboard
which does not support the SSL function.
CAUTION: The remote connection will be disconnected temporarily after changing the
SSL settings.
NOTE: This product includes software developed by the OpenSSL Project for use in the
OpenSSL Toolkit (http://www.openssl.org/).
Highlight the LAN tab, and the LAN setup screen displays.
Figure 22 ─ LAN (Manual) setup screen.
NOTE: You will need to get the appropriate IP Address, Gateway and Subnet Mask from your
network administrator.
Highlight the box beside DNS Server. Press the Up and Down arrow buttons to set the IP address
of the DNS server.
26
button to toggle between On and
Highlight the box beside Type and press the
button. You can select the type of network
configuration from: Manual, DHCP and ADSL
(with PPPoE). Select the desired type and press
the
button.
Selecting Manual from the Type allows you to
set up LAN parameters manually.
Change the numbers by highlighting them and
using the Up and Down arrow buttons to
increase or decrease the number. The factory
default LAN settings are:
IP Address:
192.168.1.129
Gateway:
192.168.1.254
Subnet Mask: 255.255.255.0
button. You can select
button to set the Quality.
Advertisement
Table of Contents
