Figure 24 ─ Rtsp Setup Screen - Eneo DLR-2004/500V Instruction Manual

Highlight the Check box and press the
can be used.
NOTE: The DVR name you entered should be checked by selecting Check, otherwise the
DVRNS changes will not be saved.
NOTE: When entering no name or a name already registered on the DVRNS server, an error
message displays.
Highlighting Save and pressing the
DVRNS settings will display the help desk information of the DVRNS server in the box beside
Help Desk.
Highlight the RTSP tab, and the RTSP setup screen displays.
Figure 24 ─ RTSP setup screen.
Highlight the box beside RTP Start Port and press the
of the RTP server obtained from your system administrator.
Highlight the box beside RTP End Port and press the
the RTP server obtained from your system administrator.
Highlight Use Mobile and press the
you can access a remote DVR using a Blackberry or other mobile devices.
NOTE: Selecting Use Mobile sets the recorded image resolution to Standard automatically
regardless of your Record settings.
NOTE: Selecting Use Mobile sets the remote watch quality to Basic automatically regardless
of your Network – Remote Watch settings.
NOTE: Selecting Use Mobile sets the WebGuard service to be enabled automatically
regardless of your WebGuard settings.
NOTE: You can access a remote DVR and monitor live video images using media players,
such as VLC Player, supporting RTSP service. Start the media player on your local PC and
enter "rtsp://ID:Password@IP address:RTSP port number/'channel number'", or start Internet
Explorer on your Blackberry or other mobile devices and enter "http://IP address:Webguard
port number/".
NOTE: RTSP service might not be supported, depending on the type of media player.
button to check whether or not the name you entered
button registers the DVR on the DVRNS server. Proper
Highlight Enable RTSP (Real-Time
Streaming Protocol) and press the
to toggle between On and Off. You will be able
to change the settings if Enable RTSP is
enabled.
NOTE: When selecting Enable RTSP, the
recorded image resolution cannot be set to
Very High during Record setup.
Highlight the box beside RTSP Port and press
the button. Set the port number of the
RTSP server obtained from your system
administrator.
button to toggle between On and Off. When set to on,
4- & 8-Channel Digital Video Recorder
button. Set the start port number
button. Set the end port number of
button
29