Video Blind; Figure 50 ─ Video Blind Settings Setup Screen - Eneo DLR-2004/500V Instruction Manual

User's Manual
NOTE: For the Record action, the camera you select should be set to the Event or Time
& Event recording mode in the Record Schedule setup screen.
Highlight the box under the Alarm-Out heading and press the
Output and Beep (DVR's internal buzzer) that you would like to activate and to sound whenever
the DVR detects video loss on the selected camera.
NOTE: For the Alarm-Out action, the alarm output and beep you select should be set to
the Event mode in the Alarm-Out setup screen (Schedule tab).
Highlight the box under the Notify heading and press the
list On and Off by highlighting Notification and pressing the
individual items On and Off by highlighting that item and pressing the
OK and press the
NOTE: For the Notify action, the notify item you select should be enabled in the Notification
setup screen and the DVR should be registered in the RAS (Remote Administration System).
Highlight the desired box under the PTZ heading, and press the
appear. Select the preset position for each PTZ camera, where you want PTZ cameras to move
to when the DVR detects video loss on the selected camera's input.
Video
Blind
Highlight Video Blind in the Event menu and press the
appears.
Figure 50 ─ Video Blind Settings setup screen.
Highlighting the box under the Activation Time heading allow you to set the duration before the
DVR will report a Video Blind. The DVR will not consider any blindness on camera video to be
Video Blind if the blindness does not last during the preset Activation Time after detected.
Highlight Use Ignoring Time and press the
set to On, the DVR will ignore video blind events occurred during the preset period. Highlighting
Time Setup and press the
46
button to accept your changes.
button allows you to set up event ignoring time.
button. Select between Alarm
button. You can toggle the entire
button. You can toggle the
button. A list of PTZ presets
button. The Video Blind setup screen
The DVR checks to see if anything is blinding
the camera. Highlighting the box under the
Sensitivity heading allows you to adjust the
DVR's sensitivity to video blind from 1 (least
sensitive) to 15 (most sensitive).
NOTE: The DVR supports both Black Blind
and White Blind detection.
NOTE: Video blind might NOT be detected
for a camera with a very noisy image
especially when set for low sensitivity
values.
button to toggle between On and Off. When
button. Highlight