Recording Video - Eneo DLR-2004/500V Instruction Manual

NOTE: In the 1+5 or 1+7 display mode, the main channel indicates the channel displayed
on the large screen which is displayed in the top-left. You can select the camera you want
to display on the main channel screen. Select a channel on the screen and click the right
mouse button to display the Camera Menu. Selecting Go To Main swaps the selected
channel with the main channel. This function is supported only in the 1+5 and 1+7 display
modes and can be activated from any of channel screens except the main channel screen.
You can change the location of the PIP (Picture-in-Picture) counterclockwise or
clockwise by pressing the Up and Down arrow buttons, and change its size by
pressing the Left and Right arrow buttons. To change its location and size by using
the mouse, select the PIP and then click the right mouse button to display the
following menu. Select the options you want. You can also change the location
of the PIP by clicking the left mouse button on the PIP window and dragging it to
where you want it located, and change the size of the PIP by clicking the left mouse
button at the corner of the PIP window and dragging it until it is the desired size.
Previous Group, Next Group
Selecting or
previous or next page.
OSD
Selecting (OSD) in the Mouse Display menu toggles OSD On and Off.

Recording Video

Once you have installed the DVR following the instructions in Chapter 2 ─ Installation, it is ready
to record. The DVR will start recording based on the settings you made in the Record setup screen.
See Chapter3 ─ Configuration.
Recycle On or Recycle Off. The factory default is Recycle On. It does this by recording over
the oldest video once the hard disk is full. Setting the DVR to Recycle Off causes it to stop recording
once the hard disk is full.
Standard (CIF), High (Half D1) or Very High (D1). The factory default resolution is Standard.
When set to Standard, the DVR has a maximum recording speed of 240 ips (120 ips for 4-channel
model). When set to High, the DVR has a maximum recording speed of 120 ips (60 ips for 4-channel
model). When set to Very High, the DVR has a maximum recording speed of 60 ips (30 ips for
4-channel model).
Pressing the
PANIC
panic recording. If you set the Panic Recording Duration in the Record Screen, panic recording
will stop automatically according to the preset duration as long as the
NOTE: When the DVR is not in the Recycle mode and all available storage space has been
used, panic recording will not operate.
(Previous Group or Next Group) in the Mouse Display menu moves to the
button starts panic recording of all cameras, and pressing the button again stops
4- & 8-Channel Digital Video Recorder
button is not pressed.
PANIC
59