User's Manual
NOTE: Mail notify is the only option available for the System event.
NOTE: For the Notify action to work, the DVR should be registered in the RAS (Remote
Administration System).
Event Status
Highlight Event Status in the Event menu and press the
screen appears.
Figure 58 ─ Event Status setup screen.
Check Alarm-In and Check Recording will be highlighted when each event is detected based
on the settings you made in the System Event setup screen on the Event menu.
Panic Record will be highlighted while the DVR is in the panic recording mode.
Disk Almost Full will be highlighted when the DVR is not in the Recycle mode and the level of
disk usage reaches the Disk Almost Full percentage you made in the System Event setup screen
on the Event menu. Disk Full will be highlighted when the DVR is not in the Recycle mode and
all available storage space has been used.
Highlighting the Storage tab will display the hard disk drive status. Refer to the Storage section
for details.
52
button. The Event Status setup
The Event Status screen displays the status of
the DVR's systems and inputs. Events will be
highlighted, and related channels or events will
flicker for five seconds when detected.
Alarm-In, Motion, Video Loss, Video Blind
and Text-In will be highlighted when each event
is detected based on the settings you made in the
Alarm-In, Motion Detection, Video Loss, Video
Blind and Text-In setup screen on the Event
menu.