Husqvarna DXR 95 Operator's Manual page 99

7. Clean the suction hose of the hydraulic fill pump (A).
A
8. Remove the plug of the suction hose (B).
9. Put the suction hose in a hydraulic oil container. Use
new hydraulic oil. Refer to
10. Press the menu button on the remote control.
11. Select "Oil refill" in the "Function" menu on the
display.
12. Read the hydraulic oil level on the display.
13. Press and hold the button (C) to fill the hydraulic oil.
The hydraulic fill pump stops automatically when the
hydraulic oil tank is full.
PRESS AND HOLD TO ACTIVATE
RELEASE TO STOP
14. Remove the suction hose from the hydraulic oil
container.
15. Install the plug of the suction hose.
16. Install the left side cover and tighten the 2 rubber
clips.
17. Start the product. Refer to
145) on page 71 .
1401 - 005 - 11.01.2024
B
Hydraulic oil on page 146 .
C
12%
OIL
REFILL
To start the product (DXR
18. Move the arm system between outer and inner end
position some times to remove air in the hydraulic
system.
19. Stop the product and make sure that there are no
leaks.
20. Read the hydraulic oil level on the display. Fill with
hydraulic oil if it is necessary.
To fill the hydraulic oil (DXR 275, DXR
305, DXR 315)
WARNING:
hydraulic oil becomes hot during operation
of the product. Let the product become cool
before you replace the hydraulic oil.
WARNING:
equipment when you fill the hydraulic oil.
Personal protective equipment on
Refer to
page 25 .
1. Park the product on level ground.
2. Fully retract the arm system.
3. Fully retract the outriggers. Refer to
outriggers on page 83 .
4. Stop the product. Refer to
275, DXR 305, DXR 315) on page 84 .
5. Open the left hatch on the product.
6. Clean the suction hose of hydraulic fill pump (A).
A
7. Remove the plug of the suction hose (B).
Risk of burn injury. The
Use personal protective
To operate the
To stop the product (DXR
B
99