Husqvarna DXR 95 Operator's Manual page 114

A
x4 (90°)
1. Move the product until you have access to all
grease nipples. The grease nipples are shown in the
illustration.
2. Stop the product and disconnect the power cord.
To stop the product (DXR 275, DXR 305,
Refer to
DXR 315) on page 84 .
3. Clean the grease nipples.
4. Replace broken or blocked grease nipples.
5. Use a grease gun to lubricate the grease nipples,
and the joints and cylinder mountings in the
outriggers and arm system. Push the grease gun 2–
3 times or until grease can be seen at the edges..
Lubricants on page 147 .
Refer to
6. Lubricate the 2 grease nipples (A) on the gear ring
bearing and the gears of the gear ring (B).
a) Lubricate the grease nipples with a grease gun.
Push the grease gun 2–3 times.
b) Start the product. Make sure that you are at a
safe distance. Refer to
275, DXR 305, DXR 315) on page 72 .
c) Turn the tower 90˚.
d) Stop the product and disconnect the power cord.
To stop the product (DXR 275, DXR
Refer to
305, DXR 315) on page 84 .
114
To start the product (DXR
30x
e) Do this procedure 3 times. The ball bearings of
the gear rings and the gears of the gear ring are
then lubricated at 4 points.
To do a check of the screw joints
• Make sure that all components are correctly
attached and that there is no wear damage.
• Use a torque wrench to do a check of the torque of
the expanding shafts. Torque the expanding shafts
to the correct torque. Refer to
(DXR 95) on page 115 and Tightening torques (DXR
145) on page 116 and Tightening torques (DXR 275,
DXR 305, DXR 315) on page 117 .
a) Tighten the expanding shafts regularly. After
initial torque, operate the product through a full
range of movements 2–3 times. Do a check of
the torque after 8 hours and 40 hours.
b) If an expanding shaft has moved out of position,
move it to the center. Then tighten the expanding
shaft again.
x4
Tightening torques
1401 - 005 - 11.01.2024