Husqvarna DXR 95 Operator's Manual page 97

10. Remove the drain plug (A) for the hydraulic oil.
11. Let the hydraulic oil drain into the container.
12. Replace the hydraulic oil filter if it is necessary. Refer
To replace the hydraulic oil filter (DXR 275, DXR
to
305, DXR 315) on page 102 .
13. Install the drain plug for the hydraulic oil and tighten
it.
14. Install the air filter and tighten it.
15. Close the left hatch on the product.
CAUTION:
when the hydraulic oil tank is empty. The
hydraulic pump will become damaged.
Fill the hydraulic oil tank with hydraulic
oil. Refer to
275, DXR 305, DXR 315) on page 99 .
To fill the hydraulic oil (DXR 95)
WARNING:
hydraulic oil becomes hot during operation
of the product. Let the product become cool
before you replace the hydraulic oil.
WARNING:
equipment when you fill the hydraulic oil.
Personal protective equipment on
Refer to
page 25 .
1. Park the product on level ground.
2. Fully retract the arm system.
1401 - 005 - 11.01.2024
A
Do not start the product
To fill the hydraulic oil (DXR
Risk of burn injury. The
Use personal protective
3. Fully retract the outriggers. Refer to
outriggers on page 83 .
4. Stop the product. Refer to
95) on page 83 . Do not disconnect the power plug.
5. Press the menu button on the remote control.
6. Select "Oil refill" in the "Function" menu on the
display and read the hydraulic oil level on the
display.
7. Remove the 4 bolts (A) and the front cover (B).
A
8. Remove the oil fill plug (C) from the oil fill hole.
C
9. Remove the air filter (D).
To operate the
To stop the product (DXR
B
A
D
A
A
97