Husqvarna DXR 95 Operator's Manual page 41

To install and remove the tools on the
product (DXR 95)
If a tool is not installed on the product, the hoses on the
tool must always be connected together.
WARNING:
correctly and safely installed. The tool can
cause serious injury if it falls off the product.
WARNING:
in the work area when you change the tool.
Prevent accidental start of the product while
you change the tool and make sure that you
can quickly stop the product. Keep hands
and feet away from areas where there is a
risk of crush injury.
1. Remove dirt from the hydraulic couplings on the
product.
2. Start the product. Refer to
95) on page 70 .
3. Put the product on a stable surface.
4. Extend the outriggers. Refer to
outriggers on page 83 .
5. Put the tool in front of the product. The holder on the
tool must point at the product.
6. Make sure that the tool is in correct position. Do the
procedure that follows:
a) Remove the 2 lock pins (A) and the 2 axles (B).
1401 - 005 - 11.01.2024
Make sure that the tool is
It can be necessary to be
To start the product (DXR
To operate the
A
b) Move the arm system until the front holes on the
tool hitch (C) aligne with the front holes on the
tool (D).
D
c) Install and front axle (E) and lock it with the lock
pin (F).
F
B
C
E
41