Husqvarna DXR 95 Operator's Manual page 100

8. Put the suction hose in a hydraulic oil container. Use
new hydraulic oil. Refer to
9. Press the menu button on the remote control.
10. Select "Oil refill" in the "Function" menu on the
display.
11. Press and hold the button (C) to fill hydraulic oil.
PRESS AND HOLD TO ACTIVATE. RELEASE
BUTTON TO STOP
12. Examine the hydraulic oil level in the sight glass on
the hydraulic oil tank. The hydraulic oil level must
not be more than 1 cm/0.39 in. below the maximum
level.
13. Release the button (C) when the hydraulic oil is at
the correct level in the sight glass.
14. Remove the suction hose from the hydraulic oil
container.
15. Install the plug of the suction hose.
16. Close the left hatch on the product.
17. Start the product. Refer to
275, DXR 305, DXR 315) on page 72 .
100
Hydraulic oil on page 146 .
C
12%
OIL
REFILL
MAX
MIN
To start the product (DXR
18. Move the arm system between outer and inner end
position some times to remove air in the hydraulic
system.
19. Stop the product and make sure that there are no
leaks.
20. Examine the hydraulic oil level in the sight glass on
the hydraulic oil tank. Fill with hydraulic oil if it is
necessary.
To replace the hydraulic oil filter (DXR
95)
WARNING:
hydraulic oil becomes hot during operation
of the product. Let the product become cool
before you replace the hydraulic oil filter.
WARNING:
equipment when you fill the hydraulic oil.
Personal protective equipment on
Refer to
page 25 .
1. Park the product on level ground.
2. Stop the product. Refer to
95) on page 83 .
3. Remove the 4 bolts (A) and the front cover (B).
A
4. Clean the area around the air filter.
Risk of burn injury. The
Use personal protective
To stop the product (DXR
B
A
1401 - 005 - 11.01.2024
A
A