Husqvarna DXR 95 Operator's Manual page 131

Messages on the display
In the bottom bar (A) of the display you can see active
messages or faults. To show the message push the
button adjacent to the quick action with the triangle
symbol (B).
12345 H
There are 4 different types of messages:
• Information messages help and give hints on how
to operate the product. An information message is
shown as an information symbol in the bottom bar.
• Caution messages show that something is not
correct. A caution message is shown as a yellow
triangle in the bottom bar.
• Warning messages show faults or safety defects
that can cause mechanical damage. The product will
stop in a short time. The warning is first shown in full
screen with a red warning triangle and text. After you
accepted (C) the warning message, the warning is
shown as a red triangle symbol in the bottom bar (A).
REPLACE WITH CHARGED BATTERY SOON
F
Fault code number
1
2
1401 - 005 - 11.01.2024
XX BAR
A
C
BATTERY
LOW
Message in the dis-
play
"Softstart error Start
not possible"
"Softstart Fault indi-
cation"
• Error messages show when the product is stopped
because of a fault or safety defect. The error
message is shown in red with a white triangle and
white text. When the fault is corrected you must
restart the product, turn the OFF/ON/START switch
to ON position. Then turn the OFF/ON/START
switch to START position.
If there are more than 1 active message, the newest
message is added from the right. Push the buttons
adjacent to the arrows (D and E) to move between the
messages in the display.
You can also find a fault list in the "Active faults"
in "Machine status" in the menu button (F). Refer to
"Machine status" menu on page 50 .
Fault codes and descriptions
The fault code numbers for the product are shown on
the display. The fault code numbers for the remote
B
control (fault code numbers from 1001) are also shown
on the information center display.
D
E
Cause
General error in soft starter.
Softstart is overload. The input
voltage is out of range.
Solution
Speak to Husqvarna service.
Do a check of the input voltage.
Let the product become cool.
If the problem stays, speak to
Husqvarna service.
131