Husqvarna DXR 95 Operator's Manual page 113

A
C
1. Move the product until you have access to all
grease nipples. The grease nipples are shown in the
illustration.
2. Stop the product and disconnect the power cord.
To stop the product (DXR 145) on page 83 .
Refer to
3. Clean the grease nipples.
4. Replace broken or blocked grease nipples.
5. Use a grease gun to lubricate the grease nipples,
and the joints and cylinder mountings in the
outriggers and arm system. Push the grease gun
2–3 times or until grease can be seen at the edges.
Lubricants on page 147 .
Refer to
6. Lubricate the 2 grease nipples (A) on the gear ring
bearing and the gears of the gear ring (B).
a) Extend the arm system until the arm system
points straight forward.
b) Open the inspection door (C) on the tower to get
access to the 2 grease nipples.
c) Lubricate the grease nipples with a grease gun.
Push the grease gun 2–3 times.
1401 - 005 - 11.01.2024
A
B
x4
d) Start the product. Make sure that you are at a
safe distance. Refer to
145) on page 71 .
e) Turn the tower 180˚.
f) Stop the product and disconnect the power cord.
To stop the product (DXR 145) on page
Refer to
83 .
g) Lubricate the grease nipples again with a grease
gun. Push the grease gun 2–3 times.
To lubricate the product (DXR 275,
DXR 305, DXR 315)
CAUTION:
lubrication is not followed, there is a high risk
that the seals of the gear ring are pushed
out. If the seals are pushed out, dirt can
go into the ball bearing of the gear ring
and cause damage. Damaged seals must
be replaced.
30x
To start the product (DXR
If the procedure for
113