Husqvarna DXR 95 Operator's Manual page 72

7. Turn the machine stop button (B) clockwise to
disengage the machine stop.
D
C
F
8. If more than one product with remote control is used
in the same workplace, do this procedure to make
sure that you have the correct remote control:
a) Turn the OFF/ON/START switch to the ON
position (C) to start the remote control.
b) Push and hold the headlights button (D) until the
connected product flashes.
WARNING:
motor before you know which
product that is connected.
9. Turn the OFF/ON/START switch to the START
position to start the motor. You will hear that the
product is on and the indicator light for operation
comes on.
10. In the display (E), make sure that the radio signal
or cable connection symbol is shown. The symbols
show that the connection between the remote control
and the product is in operation.
Note:
An error message shows in the display if
there is a fault. Refer to
page 131 .
11. Push the operation mode switch (F) up to select
work mode. Push the operation mode switch down
to select transport mode. Refer to
on page 81 .
72
E
B
Do not start the
Messages on the display on
Operation modes
To start the product (DXR 275, DXR
305, DXR 315)
WARNING:
safety PLCs operates correctly, you must
disconnect the power plug each 24 hours.
1. Turn the emergency stop button (A) clockwise to
disengage the emergency stop.
2. Connect the product to a power source.
3. Open the right hatch on the product.
4. Turn the main switch to the ON position. The
headlight comes on.
5. Close the right hatch on the product.
6. Step out of the work area with the remote control.
To guarantee that the
A
OFF
ON
1401 - 005 - 11.01.2024