Husqvarna DXR 95 Operator's Manual page 15

Display overview
1 2
12345 H
6
1. Top bar
2. Operation mode tab
3. Status bar
4. Quick action bar
5. Bottom bar
6. Product view
Fuses
The location of the fuses is in the fuse holder, behind the
cover of the electrical enclosure. For information about
low voltage (24 DC), refer to
126 .
The connection to the mains socket has high voltage
(400/460 VAC). For information about the correct fuses
for the product, refer to
a mains socket on page 150 . The product has SoftStart
and can be started with most types of fuses.
If a fuse is blown, it must be replaced. Refer to
replace a fuse (DXR 95) on page 124 or To replace a
fuse (DXR 145) on page 125 or To replace a fuse (DXR
275, DXR 305, DXR 315) on page 125 for information
about how to replace a blown fuse. If the fuse blows
again a short period after you replaced it, there is a
short circuit. Let an approved servicing agent repair the
product before you operate the product again. The fault
can be in the electrical system or in the product that it is
connected to.
Symbols on the product
WARNING: This product can be
dangerous and cause serious injury or
death to the operator or others. Be careful
and use the product correctly.
Read the manual carefully and make
sure that you understand the instructions
before you use the product.
1401 - 005 - 11.01.2024
3 4
XX BAR
5
Fuse overview on page
Guide values for connection to
To
Use heavy duty clothing that is not loose
but lets you move freely.
Use protective gloves.
Use boots with steel toe-caps and non-slip
soles.
Use respiratory protection in location
where the air can be harmful to your
health. Use a protective helmet, hearing
protection and eye protection with side
protection. Refer to Personal protective
equipment on page 25 .
High voltage.
Risk of injury. Make sure that no material
can fall down and cause damage when
you operate the product.
Risk of injury. Material can fall or eject
from the product during operation. Use
personal protective equipment and keep
distance to the product during operation.
Risk of injury. The product can overturn
when you operate or park it in slopes.
Risk of injury. Material can come in a high
speed from the side during operation. Use
personal protective equipment and keep
distance to the product during operation.
Risk of injury. Make sure that you are
above the product when you operate on
a slope. There is a risk that the product
falls.
Park the product in slopes with a
maximum of 20% inclination. Put the tool
on the ground and extend the outriggers
(DXR 95).
15