Husqvarna DXR 95 Operator's Manual page 98

10. Put a funnel in the oil fill hole and fill hydraulic oil
directly into the hydraulic oil tank.
CAUTION:
fill the hydraulic oil. The oil is filled
directly into the hydraulic oil tank. If the
hydraulic oil has contamination it can
cause damage to the hydraulic system.
11. While you fill the hydraulic oil, look at the remote
control to see when the hydraulic oil tank is full.
While you fill hydraulic oil, the work lights on the
product will flash more and more quickly. When
the hydraulic oil tank is full, the work lights on the
product will stay on with solid light. If the hydraulic oil
level is 110% or more, the horn will make a sound.
12. Remove the funnel and install the oil fill plug and the
air filter.
13. Start the product. Refer to
95) on page 70 .
14. Move the arm system between outer and inner end
position some times to remove air in the hydraulic
system.
15. Stop the product and make sure that there are no
leaks.
16. Read the hydraulic oil level on the remote control
display. Fill with hydraulic oil if it is necessary.
To fill the hydraulic oil (DXR 145)
WARNING:
hydraulic oil becomes hot during operation
of the product. Let the product become cool
before you replace the hydraulic oil.
WARNING:
equipment when you fill the hydraulic oil.
Personal protective equipment on
Refer to
page 25 .
1. Park the product on level ground.
2. Fully retract the arm system.
98
Be careful when you
To start the product (DXR
Risk of burn injury. The
Use personal protective
3. Fully retract the outriggers. Refer to
outriggers on page 83 .
4. Stop the product. Refer to
145) on page 83 .
5. Open the 2 rubber clips.
6. Remove the left side cover.
To operate the
To stop the product (DXR
1401 - 005 - 11.01.2024