Husqvarna DXR 95 Operator's Manual page 141

2. Attach the lifting equipment at the lifting eyes on the
product.
To attach the product to a
transportation vehicle
Attach the product during transportation to prevent
accidents and damage to the equipment. Use tie-down
straps to attach the product to the transportation vehicle.
Use different tie-down straps for the tools and other
equipment.
1. Put the product against the front edge of the
transportation vehicle.
2. Start the product. Refer to
95) on page 70 and To start the product (DXR 145)
on page 71 and To start the product (DXR 275, DXR
305, DXR 315) on page 72 .
3. Move the arm system until it is against the floor of
the transportation vehicle.
4. Engage the swing lock (DXR 95), refer to
check of the rotation lock (DXR 95) on page 37 .
5. Extend the outriggers. Refer to
outriggers on page 83 . The product must stay on the
floor of the transportation vehicle.
6. Stop the product. Refer to
95) on page 83 and To stop the product (DXR 145)
on page 83 and To stop the product (DXR 275, DXR
305, DXR 315) on page 84 .
1401 - 005 - 11.01.2024
To start the product (DXR
To do a
To operate the
To stop the product (DXR
7. Put 2 tie-down straps around the chassis.
a) Put 1 tie-down strap around the front part of the
chassis and attach the strap to the vehicle.
b) Put 1 tie-down strap around the rear part of the
chassis and attach the strap to the vehicle.
To tow the product
Only tow the product if the position of the product is a
risk and there is no other solution. When the hydraulic
system is empty, the parking brake of the drive motor
is engaged. When the parking brake is engaged, the
caterpillar tracks cannot move.
• If it is possible, retract the outriggers.
• Attach the tow equipment to the chassis of the
product.
• Before you tow the product, clean the ground to
decrease the load on the tow equipment and the
mechanical components.
• If it is possible, tow in the direction of the caterpillar
tracks.
• Only tow the product for short distances and at low
speed.
141