Husqvarna DXR 95 Operator's Manual page 43

a) Make sure that the return hose is on the right
side of the product (A).
B
b) Make sure that the pressure hose of the tool is
on the left side of the product (B).
7. Move the arm system until the tool holder on the arm
system holds the tool.
8. Lift the arm system and fully retract cylinder 4 (C) to
tighten the tool on the tool holder.
C
1401 - 005 - 11.01.2024
9. Turn the OFF/ON/START switch on the remote
10. Install the wedge from the right. The stop notch on
A
11. Use a hammer to fully lock the wedge.
12. Install the locking pin into the wedge. Put the locking
13. Connect the hoses from the tool to the product. Do
control to the OFF position.
the wedge must point up.
pin in the hole that is nearest the tool.
the procedure that follows. The tool is seen from the
rear side.
43