Husqvarna DXR 95 Operator's Manual page 86

• Some components on the product become very hot
during the operation. Let the product become cool
before you do maintenance.
• Make sure that the area is sufficiently illuminated.
• Use lifting equipment to lift heavy product parts
and to keep them in a stable position during
maintenance. Lock product parts mechanically
before maintenance to prevent injury from moving
parts.
• Clean the area around the product from oil and dirt.
Remove unwanted objects.
• Clean the product. Dirt in the hydraulic system can
cause damage.
• Keep fire extinguishers, medical supplies and an
emergency phone near.
General product maintenance
Make sure that fasteners on the arm system and the out-
rigger system are tightened. Tighten the fasteners if it is
Tightening torques (DXR 95) on page
necessary. Refer to
115 and Tightening torques (DXR 145) on page 116 and
Tightening torques (DXR 275, DXR 305, DXR 315) on
page 117 .
Make sure that hammer grease is supplied to the breaker
working tool.
Do a check of the hydraulic cylinders, the slew motor and
the drive motor.
Lubricate all joints and cylinder mountings on the arm sys-
tem and tool hitch. Refer to
95) on page 111 and To lubricate the product (DXR 145)
on page 112 and To lubricate the product (DXR 275, DXR
305, DXR 315) on page 113 .
Make sure that bolts and fasteners are tightened. Tighten
the bolts and fasteners if it is necessary.
Do a check for leakage in the cylinders and the hoses.
Examine the power cord, the connectors and the sockets
To examine the electric cables for
for damage. Refer to
wear on page 110 .
Examine the caterpillar tracks and outriggers for damage.
To examine the product for cracks on page 111 .
Refer to
Do a check of the hydraulic oil level. Refer to
of the hydraulic oil level (DXR 95, DXR 145) on page 93
To do a check of the hydraulic oil level (DXR 275, DXR
and
305, DXR 315) on page 93 .
Do a check of the grease level in the breaker grease pump/
grease cartridge.
Make sure that breaker grease is supplied to the tool.
86
To lubricate the product (DXR
To do a check
• Lock product parts that can move mechanically
before you loosen the screw joints or disconnect the
hydraulic hoses.
• Be careful when you disconnect connections. The
pipe and hose couplings can stay pressurized
although the product is stopped.
• Put marks on all the cables and the hoses to make it
easier to assemble the product correctly.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
First 8 Week-
Daily
h ly
X X
*
*
X
*
X
X
*
X
X
X
Each Each Each
250 h 500 h 1000 h
1401 - 005 - 11.01.2024