Husqvarna DXR 95 Operator's Manual page 81

Operation modes
The operation mode switch (A) is used to select
between work mode and transport mode.
H
D
C
E
1
3 B
G
A
In work mode you can operate arm 1, arm 2, arm 3, the
tools and the tower.
The transport mode is divided into 3 modes. The
transport mode switch (B) is used to select between the
3 transport modes.
• One lever control (C): The caterpillar tracks, the
outriggers, the tower and some arm functions can be
operated. The left joystick (D) controls the caterpillar
tracks.
• Two lever control (E): The caterpillar tracks and the
outriggers can be operated. The left joystick controls
the left caterpillar track. The right joystick (F) controls
the right caterpillar track.
• Crawl (G): The caterpillar tracks, the tower and all
arm functions can be operated. The top button (H)
and the side switch (I) on the left joystick controls the
caterpillar tracks. The caterpillar tracks can only be
moved straight forward or rearward.
If the joysticks on the remote control are not used for 3
seconds, the product goes to idle mode. The hydraulic
oil goes into the hydraulic oil tank and there is no
pressure in the cylinders.
Joystick pattern
The remote control has 4 joystick patterns. "Pattern 1" is
used as standard, refer to
can change the joystick pattern in "Joystick setup" in the
"Controls" menu on the display. Refer to
on page 51 .
1401 - 005 - 11.01.2024
I
"Pattern 1" on page 52 . You
"Joystick setup"
WARNING:
Make sure that you know which joystick
pattern that is in operation before you
operate the product. Do a check in the
status bar in the display. Refer to
in the status bar on the display on page 19 .
To operate the tools
1. Push the operation mode switch (A) up to select
work mode.
F
1
3
2. Use the left joystick as shown in the illustration
below.
Position Use
To adjust the pressure or the flow to the
1
breaker.
2 To give full pressure or flow to the breaker.
Risk of injury and damage.
A
1 2
3 4
5 6
7 8
Symbols
81