Installation Of Devices With Threaded Connection, Flange Connection, Clamp Connection Or Bonded Connection - Burkert 3363 Operating Instructions Manual

Typ 3363, 3364, 3365
Installation
9.3 Installation of devices with threaded connection,
flange connection, clamp connection or bonded
connection
ATTENTION!
Damage to the diaphragm.
▶ To prevent damage, the device must be in MANUAL operating state during installation.
Devices in their factory default state already have their operating state set to MANUAL.
9.3.1 Required work steps
1. If not already preset, set MANUAL operating state, chapter "14.1" on page 113.
2. If device is already electrically connected, shut off power supply. Wait until LED illuminated ring goes out.
3. Install device in pipeline, chapter "9.3.3" on page 51.
4. Electrical installation, chapter "10" on page 65.
5. Connect supply voltage.
6. Execute TUNE function for adjustment of position control, chapter "11.5" on page 83 (AG2) and "11.6"
on page 86 (AG3).
7. Set AUTOMATIC operating state, chapter "14.1" on page 113
9.3.2 Installation conditions
Pipelines: Ensure that pipelines are in alignment.
Preparation: Clear impurities from pipelines (seal material, metal chips, etc.).
Support and align pipelines.
To ensure that the pipeline is self-draining, we recommend the inclination angles according
to the valid ASME BPE.
9.3.3 Install device in the pipeline
Prerequisite: MANUAL operating state.
ATTENTION!
The following must be heeded when installing the device in the system.
The device and relief bore must be accessible for inspections and maintenance work.
DANGER!
Risk of injury from high pressure.
▶ Before working on the system, switch off the pressure and vent or empty the lines.
WARNING!
Risk of crushing by mechanically powered parts.
▶ Do not reach into the openings of the valve body.
English
51