Remove The Rear Wheel - Skyjack SJ12 E Service Manual

Wheels
6. Insert a 1/8" x 2" cotter pin through the holes in
the spindle, with the long arm of the cotter pin
on the outside. Push the cotter pin in all the
way.
7. Bend the long end of the cotter pin over the end
of the spindle to secure the castle nut.
8. To limit rust bleed, apply a few drops of grease
to the two small tapped holes in the wheel.
SJ12 E, SJ16 E, SJ20 E

5.10-3 Remove the rear wheel

1. Use an appropriately rated lifting device to raise
the MEWP until the wheels are off the ground.
Set the MEWP on stands which are adequately
rated to support the weight of the machine.
2. Remove and set aside the dust cap.
3. Remove and discard the cotter pin.
4. Remove and set aside the flast washer and the
castle nut.
5. Remove the wheel from the spindle.
6. From the rear side of the wheel, put the grease
seal on the hub with the tapered end pointing in.
Section 5 – Procedures
241914ACA
165