Visual and daily maintenance inspections
4.2-5 Wheel/tire assembly
Do the inspection that follows:
Wheel/tire assembly
1
Do a check on all the tire treads and sidewalls
▪
for cuts, cracks, and unusual wear.
Do a check on each wheel for damage, and
▪
cracked welds.
Make sure the wheels are correctly aligned
▪
vertically and horizontally.
Make sure there is no visible damage.
▪
WARNING
Do not use tires other than the tires that Skyjack
specifies for this MEWP . Do not mix different types
of tires or use tires that are not in good condition.
Only replace the tires with the same types that are
approved by Skyjack. The use of other tires can
make the MEWP less stable. If you do not obey,
there is a risk of death or serious injury.
Wheel nuts
2
Make sure the castle nut is in position and is
▪
tight.
Make sure the cotter pin is correctly installed.
▪
SJ3215, SJ3219, SJ3220, SJ3226, SJ4726, SJ4732, SJ4740
Example model SJ4740
2
1
Section 4 – Inspections Before Operation
216380ACA
35