Skyjack SJ12 E Service Manual page 149

Display Module
Name Unit of Measure
IQIMAX LIM BRK
MOT POWER
WATT
STATOR FLUX
MWB
MOTION TORQUE
NM
STEER ANGLE
TEMPERATURE
1
M65-M2 TEMP
DC PUMP
CURRENT
DC PUMP VMN
B2 LIFT B
B6 LOWER B
B7 B MODE
B12 P MODE
B8 DIAGNOST
B3 ELEVATED
B11 BRK REL
B4 TILTED
A8 CHARGER
A23 TELEMAT
B22 SET EVP2
B16 EV5
B17 EV6
B18 EV7
B20 EV8
B21 EV9
JOYD 1:DRIVE M
JOYD 2:LIFT M
SJ12 E, SJ16 E, SJ20 E
Description
Slave motor: instantaneous value of the maximum current the inverter can apply
Ampere
to the motor to satisfy a braking request. The value is evaluated basing on the
(1 A)
real-time conditions (inverter temperature, motor temperature, etc.).
Watt
Slave Motor: Estimation of the power supplied to the motor.
(1 W)
10-3 Weber
Slave Motor: estimation of the motor magnetic flux.
(0.1 mWb)
Nm
Slave motor: estimation of the motor torque.
(0.1 Nm)
Degrees Current steering wheel angle. When the steering is straight ahead STEER
(1°) ANGLE is zero.
Celsius Temperature measured on the master-side power board.
(1 °C) This temperature is used for the HIGH TEMPERATURE alarm.
Celsius Slave Motor: windings temperature.
(1 °C) This temperature is used for the MOTOR OVERTEMP alarm.
Ampere
DC current of the pump motor.
(1 A)
Percentage Voltage applied to the pump motor.
(1%) Duty cycle of the PWM applied to the motor.
OFF/ON Status of the Base Mode Lift Input
OFF/ON Status of the Base Mode Lower Input
OFF/ON Status of the Base Mode Active Input
OFF/ON Status of the Platform Mode Active Input
OFF/ON Status of the Diagnostic Active Input
OFF/ON Status of the Mast Position Limit Switch
OFF/ON Status of the Emergency Brake Release Switch
OFF/ON Status of the External Tilt Switch
OFF/ON Status of the Battery Charger, When ON function is diabled
OFF/ON Status of the Telematics Input
Percentage Setpoint of the proportional electrovalve EVP2, on output NEVP2 B22. (Brake
(1%) Release Relay)
OFF/ON Spare
OFF/ON Spare
OFF/ON Status of the EV7 Output (Power LED) Base E-Stop
OFF/ON Status of the EV8 Output (Flashing Lights)
OFF/ON Status of the EV9 Output (Horn)
OFF/ON Status of the Digital Input at the Platform Joystick for Drive Mode
OFF/ON Status of the Digital Input at the Platform Joystick for Lift Mode
Section 5 – Procedures
241914ACA
149