Sod (Stationary Object Detection) - urmet domus 1097 User Manual

➢
Select one of the Rule Number. It is the number of LCD lines. Up to four lines can be drawn.
➢
To enable the detection in Rule Switch.
➢
Select a Rule Type:
▪
A→B: HVR will only detect the action from side A to side B.
▪
B→A: HVR will only detect the action from side B to side A.
▪
A→B: The HVR will detect the action from either side B to side A or side A to side B.
➢
Click on two points in the camera picture to draw a virtual line.
➢
Click on Save to save the settings.
➢
If you want to modify the position or length of the line, click on the red box in the line, the line will be changed to
red. Hold the left mouse button pressed to move the line or drag the terminals to modify the length or position of
the line.
➢
If you want to remove one of the lines from the camera picture, click on the red box in the line and then click on the
Remove button. Clicking on Remove All will delete all lines.
Warning:
o
The lines shall not be too close to the edges of the camera picture, to avoid any failure to trigger an alarm
when the target cross through it.
o
The lines shall not be set too short, to avoid any failure to trigger an alarm when the target passes outside it.

SOD (Stationary Object Detection)

This function detects the objects left over or lost in the predefined area such as luggage, bags, hazardous materials, etc.,
and a series of actions can be taken when the alarm is triggered. This alarm is only available for IP cameras
DS1097-024C 38