FIRST HVR LOGIN
For the first time when you run the HVR, you must be required to set your password immediately to protect your privacy.
Please be sure to record your username and password and save them in a secure place.
•
Language: Select an OSD language
•
Device ID: Input the device ID in the brackets. Default ID: 000000.
•
New Admin Name: Enter the name of your administrator.
•
Password Strength: This shows how safe the edited password is.
•
New Admin Password: enter your password. To be accepted by the device, the password must meet specific
criteria that determine its strength.
•
Confirm Password: Enter your password again.
•
Pattern: If you enable this function and store and confirm a drawn pattern, each time you will draw a Pattern to
login into the HVR system.
Click on Apply to confirm your settings and goes to the login interface. Enter your user name and password to Login the
HVR system.
NOTE: In case you forget your password, you can reset it via the hole (RESET) on the back of the HVR. Pressing it should
last 10 seconds after which there is an audible warning (3 beeps) and the device restarts.
It is also possible to set security questions for password recovery as shown in the screenshot below:
DS1097-024C
15