Ptz - urmet domus 1097 User Manual

PTZ

This menu can be used to configure the PTZ (Pan-Tilt-Zoom) settings for the dome camera
PTZ
To control PTZ cameras, click on PTZ (that stands for Pan Tilt and Zoom) to open the page shown in the following figure.
On each channel, you can set the communication protocol, speed and other information, as shown below:
DS1097-024C
Select a channel to be configured.
Select the desired integrated IR cut filter mode to ensure the
camera works correctly in D/N. Set the IR-CUT switching delay time.
Check to enable lens flip and angle flip
Set the flip angle.
To enable or disable backlight compensation.
Select the backlight compensation level and the application area
.
To enable or disable 3D noise reduction function setting the level.
To enable or disable Wide Dynamic Range by increasing white dynamics.
To enable or disable high light compensation, choose the
desired compensation level.
Automatic gain control: OFF/Low/Middle/High
To enable or disable white balancing: Auto/Manual
To set the Auto/Manual shutter mode.
Set the shutter mode in Auto/Manual
Set Defog mode: Disable/Auto/Manual mode, if Defog is set to manual, set level to
improve the video quality.
Click on Default to load the default settings.
30