Preset Function - Rigol DG900 Pro Series User Manual

Preset Function

18
Preset Function
DG900 Pro provides one auto memory location (AUTO_RECALL) and five user-defined
state memory locations (STATE_1 to STATE_5). You can store the instrument states to
the specified state memory locations and recall them when necessary. Stored states
include channel parameters, waveform parameters, and system parameters. Click or
tap > Preset to enter the "Preset" menu, as shown in the figure below.
TIP
Load Last
If
last power-down (stored in AUTO_RECALL) when it is powered on. Also, the AUTO_RECALL is
grayed out and cannot be modified.
Restore Default Settings
Click or tap Default > Apply. Then click or tap OK in the pop-up menu to reset the
instrument to factory default settings. You can also press the front-panel
For the factory default values, refer to
Store Instrument States
Click or tap one state from STATE_1 to STATE_5. Then click or tap Save to save the
current system state to the specified location in the internal non-volatile memory. If
Load Last
an existing state file has been stored, this operation overwrites the original file.
Recall Instrument States
When a state file has been stored in the specified location, you can select the location
and then click or tap Apply > OK to recall the state file.
DG900 Pro User Guide
104
Figure 18.1 Preset Menu
is set to "Last", the instrument automatically recalls the system configurations at
is set to "Default", you can also store the system state to AUTO_RECALL. If
Table 18.1 Factory Settings
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
key.
.