5
Continuous
Click or tap the "Output Mode" drop-down button to select "Cont" and configure the
channel to output continuous waveform. The Continuous setting interface is as shown
in the figure below.
After setting the output mode to "Cont", you can configure the selected channel to
output the following waveforms and then view the created waveform in the waveform
preview area.
•
Sine Wave
•
Square Wave
•
Ramp Wave
•
Pulse
•
Noise
•
Arbitrary Waveforms
•
Harmonic
The following tables show the ranges of the waveform (except noise) frequency and
amplitude respectively.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Tabs
Waveform Preview/Selection
Figure 5.1 Continuous Setting Interface
Continuous
DG900 Pro User Guide
29