Burst
8
Burst
DG900 Pro can output a waveform for a specified number of cycles, called a burst.
You can use Sine, Square, Ramp, Arb (except DC), and Noise (only available for
"Gated" Burst) to generate burst waveforms.
Click or tap the "Output Mode" drop-down button to select "Burst" to enter the Burst
Setting Interface, as shown in the figure below. You can click or tap one of the tabs at
the bottom to enter the Continuous Setting Interface, Burst Setting Interface, or
Channel Setup Interface. For Continuous Setting Interface and Channel Setup
Interface, please refer to
only describes the burst settings.
TIP
The Burst mode cannot be enabled when the fundamental frequency is less than or equal to
125 μHz.
DG900 Pro User Guide
68
Continuous
Channel Setup
and
Tabs
Figure 8.1 Burst Setting Interface
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
respectively. This chapter
Burst Type