Rigol DG900 Pro Series User Manual page 24

Quick Start
For details about the characteristics of the sync signals corresponding to various
output signals, please refer to
- Modulation input: when an external modulation source is selected for CH2,
this connector accepts an external modulation signal. For details about external
modulation, please refer to
- Trigger input: when the Sweep or Burst mode is selected for CH2 and an
external trigger source is selected, this connector accepts an external signal as
the trigger signal of CH2. The polarity of the signal can be set.
- Trigger output: when the Sweep or Burst mode is selected for CH2 and the
trigger output is enabled, this connector outputs a trigger signal with a
specified edge type.
2. [CH1 AUX IN/OUT]
BNC female connector. Its function is determined by the current work mode of
CH1.
- Sync output: When the Sync output of CH1 is enabled, this connector outputs
the corresponding sync signal that matches the current configuration of CH1.
For details about the characteristics of the sync signals corresponding to various
output signals, please refer to
- Modulation input: when an external modulation source is selected for CH1,
this connector accepts an external modulation signal. For details about external
modulation, please refer to
- Trigger input: when the Sweep or Burst mode is selected for CH1 and an
external trigger source is selected, this connector accepts an external signal as
the trigger signal of CH1. The polarity of the signal can be set.
- Trigger output: When the Sweep or Burst mode is selected for CH1 and the
trigger output is enabled, this connector outputs a trigger signal with a
specified edge type.
3. [10 MHz In/Out]
BNC female connector. Its function is determined by the clock type used by the
instrument.
- When internal clock source is selected, this connector (as 10 MHz Out) outputs
the 10 MHz clock signal generated by the internal crystal oscillator inside the
generator.
- When external clock source is selected, this connector (as 10 MHz In) accepts an
external clock signal.
This connector is usually used to synchronize multiple instruments. For clock
source settings, refer to
4. LAN
DG900 Pro User Guide
16
Sync Signal Setup
Modulation
.
Sync Signal Setup
Modulation .
Basic Settings
.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
.
.