Table of Contents
Advertisement
Coupling Setup
TIP
•
When the coupling mode is set to "ratio", if the frequency, amplitude or phase of any
channel exceeds the upper/lower limit after calculation according to the coupling rules
due to modifying the coupling ratio, switching waveform, or changing waveform
parameters, the generator will automatically adjust the waveform parameters of the base
channel to avoid parameter overlimit.
•
When the coupling mode is set to "deviation", if the frequency, amplitude or phase of
any channel exceeds the upper/lower limit after calculation according to the coupling
rules due to modifying the coupling deviation, the generator will automatically adjust the
coupling deviation to avoid parameter overlimit; if it is due to switching waveform or
changing waveform parameters, the corresponding coupling function is disabled.
•
The coupling function is disabled when the channel track or counter is enabled.
DG900 Pro User Guide
92
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Advertisement
Table of Contents
