11. CH2 Output Connector
BNC type connector with 50 Ω nominal output impedance. When the CH2 output
is enabled, the CH2 output connector outputs the waveform in the current
configuration.
12. CH1 Output Connector
BNC type connector with 50 Ω nominal output impedance. When the CH1 output
is enabled, the CH1 output connector outputs the waveform in the current
configuration.
13. USB HOST Interface
Reads the waveform or state files stored in the USB storage device; saves the
current instrument states or edited waveform data into the USB, or saves the
content displayed on the screen to the USB in the format of a captured image.
FAT32, NTFS, and exFAT formats are supported.
14. Power Key
Powers the signal generator on or off.
4.4.2
Rear Panel Overview
3
2
1
1. [CH2 AUX IN/OUT]
BNC female connector. Its function is determined by the current work mode of
CH2.
- Sync output: When the Sync output of CH2 is enabled, this connector outputs
the corresponding sync signal that matches the current configuration of CH2.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
9
Figure 4.5 Rear Panel
Quick Start
4
5
6
7
8
DG900 Pro User Guide
15