Setting The Scan Resume Function; Dsetting The Scan Delay Timer; Dsetting The Scan Resume Function; Setting The Priority Interval - Icom IC-R8600 Instruction Manual

Setting the Scan Resume function

D Setting the scan delay timer
You can set the delay time that the scan restarts after
the signal disappears.
z Rotate .
• Setting range: 1 ~ 30 seconds
LThe delay amount is displayed while setting.
L If a signal is received before the delay time has
expired, the timer restarts.
L When the Scan Resume function is set to [OFF] or [∞],
the scan delay is not activated.
D Setting the Scan Resume function
You can set the Scan Resume options for when the
signal disappears.
1. Hold down for 1 second.
• The SCAN DELAY screen opens.
2. Touch the resume condition option.
• [OFF]: The scan pauses until the signal
disappears.
• [DELAY]: When a signal is received, the
scan pauses for the preset delay
period, then resumes.
(
Set the delay by rotating
• [ ](Infinity): T he scan is cancelled when a
∞
signal is received.

Setting the priority interval

Priority scan checks the priority channel according to
the set interval.
1. Push .
• The setting menu opens.
2. Touch [PRIO INTVL].
3. Rotate .
• Setting range: 1 ~ 15 seconds

Priority scan

90.6 MHz (VFO)
A priority scan periodically checks a selected memory
channel* while receiving on a VFO frequency.
* Memory channel, Auto Memory Write channel, Scan Skip
Channel or Program Scan Edge Channel.
D Priority scan operation
1. Open the SCAN screen.
» SCAN
MENU
2. Touch [TYPE/SET].
3. Touch [PRIO].
4. Touch [SELECT] to select the item to change.
• No.: Priority memory preset number (0 ~ 9)
(You can save up to 10 pairs of Group and Ch.)
• Group: Memory Group number
• Ch: Memory channel number.
5. Rotate
.)
LYou cannot select blank channels.
6. Touch [SELECT] several times to exit the edit
mode, then touch [START] or push
• A Priority scan starts.
• To cancel the scan, push
7. To close the SCAN screen, push
D Monitoring the Priority channel
z During a Priority scan, hold down
1 second to monitor the priority channel.
• "PRIO" is displayed while monitoring.
• Push
9-2
SCANS
(Example)
145 MHz (Memory channel)
SCAN screen
to change the setting.
or touch [STOP].
to cancel the monitoring.
9
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
.
18
Blinks
19
20
21
.
for