ABB ProKiln GAC400 Operating Instruction page 82

82 ProKiln GAC400 PROBE GAS SAMPLING SYSTEM | OI/GAC400-EN REV. A
... 11 Maintenance
... Maintenance schedule
Retractor
Maintenance task
If necessary, remove dust and debris around chain drive Probe retractor: Checking and tightening the
Check and if necessary, tighten drive chain
Check and grease chain drive bearings
Check and, if necessary, adjust the position of the probe Probe retractor: Checking and tightening the
Cooling system
Maintenance task
Check cooling water for deposits in tank
Check cooling-water system for leaks
Check that the water flow is sufficient
Check that heat exchanger dissipation fins are clean
Pneumatic system
Maintenance task
Check pneumatic-air system for leaks
See...
drive chain on page 117
Probe retractor: Checking and tightening the
drive chain on page 117
Instructions on page 118
drive chain on page 117
See...
Instructions on page 122
Cooling module: Checking cooling water on
page 122
Cooling module: Checking cooling water on
page 122
See...
Checking the pneumatic system on page 62
Inspection / Maintenance intervals
X X
X
X X
Inspection / Maintenance intervals
X X
X
X X
Inspection / Maintenance intervals
X X
X
X
X
X