ABB ProKiln GAC400 Operating Instruction page 37

ProKiln GAC400 PROBE GAS SAMPLING SYSTEM | OI/GAC400-EN REV. A
Transporting the modules
Observe the following instructions with regards to transporting the modules:
Module Weight
Retractor unit including 700 to 900 kg •
the probe
Cooling unit 350 kg
Water unit 250 kg
Control cabinet 75 kg
Flange shutter 50 kg
Transport condition
The retractor is delivered with two temporary transportation legs. They are removed when assembled on the location.
• During storage, support the tip of the assembled probe.
• Only store after draining all water.
Lifting gear may only be attached at the designated attachment points 1 (4 lifting lugs included, see below).
•
Transport recommendation: Crane
Note: The unpacked retractor must not be transported using a fork-lift truck.
• Only store after draining all water.
Lifting gear may only be attached at the designated lifting points 1 (see below).
•
<
Transport recommendation: Fork-lift truck or crane
• Only store after draining all water.
Transport recommendation: Fork-lift truck.
• Lay the control cabinet on its back for transport.
• Use a suitable transport pallet for transport.
Transport recommendation: Fork-lift truck or hand lift (recommended at least 2 persons for hand-lifting)
• Lay the flange shutter its back for transport.
• Use a suitable transport pallet for transport.
Transport recommendation: For-lift truck or hand lift (recommended at least 2 persons for hand-lifting)
1
1
37