Printer Restart. Check Last Job; Bin Full. Remove Paper; Parallel Port Disabled [56]; Rear Usb Port Disabled [56] - Lexmark MS410 Series Service Manual

If you do not wish to accept these risks, then remove the third‑party supply or part from your printer, and then install
a genuine Lexmark supply or part.
Note: For the list of supported supplies, see the "Ordering supplies" section of the User's Guide or visit
http://support.lexmark.com.

Printer restart. Check last job.

Press on the printer control panel to clear the message and continue printing.
For more information, visit

Bin full. Remove paper.

Remove the paper stack from the standard bin.

Parallel port disabled [56]

Try one or more of the following:
•
From the printer control panel, press
Note: The printer discards any data received through the parallel port.
•
From the printer control panel, set Parallel Buffer to Auto.

Rear USB port disabled [56]

Try one or more of the following:
•
From the printer control panel, press
Note: The printer discards any data received through the USB port.
•
From the printer control panel, set USB Buffer to Auto.

Too many trays. Remove some. [58]

1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the extra trays.
4
Connect the power cord to the electrical outlet.
5
Turn the printer back on.
http://support.lexmark.com
to clear the message and continue printing.
to clear the message and continue printing.
Diagnostic information
or contact customer support.
36
4514-420, -430