Table of Contents
Advertisement
Teldat
Note
Please keep in mind that the specific model of the power supply unit (PSU) delivered with the device
may vary. For more details on the PSU models, please refer to
Warning
It is important to use the power supply provided by the manufacturer when operating the equipment.
To power up the router, connect the power supply to both the mains supply and the DC connector.
Fig. 16: DC Connector
3.5 RST button
Here are the different functions of the RST button:
RST button
Fig. 17:
3.5.1 Rebooting the device
Pressing the RST button while the device is operating normally will initiate a restart.
3.5.2 Default configuration
Follow these steps to use the RST button and restore the device to its default configuration:
• With the device powered off, press and hold the RESET button until the device powers on.
• The PWR (green) light will illuminate and the WLAN LED will start blinking in yellow. This blinking will continue for
10 seconds.
• To boot the device with the default configuration, release the Reset button while the WLAN LED is still blinking
(before the 10-second limit elapses).
After the default configuration is established, the router will have the following access IP address and mask:
• IP address: 192.168.1.1
• IP mask: 255.255.255.0
Note
Some devices may have customized settings when they leave the factory, so the default configuration
of your router (and that of the embedded access point, if applicable) may differ from what is shown
above.
Teldat M2/M2L
3 Components and Power Supply
PSU energy efficiency
on page 25
15
Advertisement
Table of Contents
