Related Manuals for Teldat G1N
Summary of Contents for Teldat G1N
- Page 1 Manual Teldat S.A. Teldat Router G1N Installation Manual Copyright© Teldat-DM431-I Version 4.0 7/2015 Teldat S.A. Teldat Router G1N...
- Page 2 This publication is subject to change. Teldat S.A. offers no warranty whatsoever for information contained in this manual. Teldat S.A. is not liable for any direct, indirect, collateral, consequential or any other damage connected to the deliv- ery, supply or use of this manual.
-
Page 3: Table Of Contents
External Power Source ....... . A.4.8 Dimensions and Weight ....... . Teldat Router G1N... - Page 4 Recycling and the Environment ......Translated Safety Warnings ......Teldat Router G1N...
-
Page 5: I Important Information
Furthermore, it is crucial to avoid any kind of contact between the device components and necklaces, bracelets, rings, ties etc. Teldat Router G1N... -
Page 6: Chapter 1 Description
Chapter 1 Description 1.1 Introduction The Teldat G1N routers family is composed of a range of IP routers for general purposes with a wide application area: personal environments, SOHO/SME and corporative. The Teldat G1N is an additional member of this family. -
Page 7: Chapter 2 Installation
Turn the power supply switch to the ON position 2.1.1 Power Source Connection The Teldat G1N router is powered with an external AC/DC source. To avoid electric shocks, residual current circulation and other unwanted effects, also affecting communications, the following is recommended:... -
Page 8: Data Connection
WWAN main, which is located on the rear of the device. Antenna installation is essential in the Teldat G1N routers in order to improve the quality of the signal received and transmitted by the Wireless WAN module (GSM). - Page 9 In order to achieve optimum features, the installed radio frequency accessories (antenna and cables) should be those recommended by Teldat. Teldat has a series of accessories (90º mount antennas, exterior antennas, ceiling antennas, extension cables, etc.) enabling the Teldat G1N routers to be installed in different locations.
-
Page 10: Connecting To The Wlan Antenna
2.1.5 Connecting for configuration The Teldat G1N routers have a RJ45 female connector on the front panel referred to as “ Conf.” which provides ac- cess to the device local console. In order to configure this, you must connect the “ Conf.” port to an asynchronous ter- minal (or to a PC with terminal emulation). -
Page 11: Installing The Sim Card
Fig. 7: 2.2 Installing the SIM card The Teldat G1N routers have a Wireless WAN interface that, in order to operate, may require at least one SIM card that must be inserted into the device. The Teldat G1N routers have two SIM trays. One is accessible from the outside and the other is located inside the device. -
Page 12: Installing The External Sim
(5) While pressing on the tray, push the fastening towards the inside of the tray (LOCK). (6) The card should be completely held by the tray. 2.2.2 Installing the external SIM The external SIM tray is located on the rear of the device. The following figure shows where you can find it. Teldat Router G1N... - Page 13 • Subsequently, you need to place the SIM on the tray so that its connectors can be seen; these are normally a gold color. In addition, you must make sure that the tray notch coincides with the SIM notch. • Then insert the tray in the slot using the guides. Teldat Router G1N...
-
Page 14: Chapter 3 Meaning Of The Leds
Teldat S.A. Chapter 3 Meaning of the LEDs The following figure shows the positions of the LEDs on the front panel of the device: Teldat G1N: Front panel Fig. 10: Power-on indicator. It lights up when connected to the power. -
Page 15: Chapter 4 Microswitches
Teldat S.A. Chapter 4 Microswitches The Teldat G1N router has a block of 8 microswitches available that are used for maintenance and test tasks. In this case, they are only used to load the default configuration. This block of microswitches can be found on the underside of the Teldat G1N routers. - Page 16 Press any key to get started On reaching this point, you can set microswitch ‘5’ in the OFF position (you don’t need to turn off the device). This way, the next time you restart the device, the saved configuration is adhered to. Teldat Router G1N...
-
Page 17: Appendix A Technical Information
Get your technical service to check that the device is in the optimum position for the service. A.2 Upgrading the software The Teldat G1N router family can be updated to new releases. Please consult your distributor for further details on new releases. There are various ways to upgrade a Teldat router. -
Page 18: Lan Connector
Technical Information Teldat S.A. A.3.1 LAN Connector RJ45 PIN RJ45 LAN (input) (input) Rx+(output) Rx-(output) A.3.2 WWAN Connectors Internal RF in/out External A.3.3 WLAN Connectors Internal RF in/out External Teldat Router G1N... -
Page 19: Configuration Connector
Please see the manual on the antennas for Cellular and GPRS interfaces. A.4.4 Wireless LAN Interface STANDARDS Please see the manual on Wireless LAN SPEED Please see the manual on Wireless LAN CONNECTOR 2 RF SMA Female Teldat Router G1N... -
Page 20: Configuration Interface
220 x 220 x 30 mm WEIGHT 0,9 kg A.4.9 Environmental Specifications AMBIENT TEMPERATURE ON: 5º to 45 ºC. OFF: -20º to 60 ºC RELATIVE HUMIDITY ON: 8 % to 85%. OFF: 5 % to 90 % Teldat Router G1N... -
Page 21: Appendix B Safety Information
B.1 Recycling and the Environment Please do not, under any circumstances, throw away any Teldat G1N with normal domestic waste. Ask your local town hall for information on how to correctly dispose of them so protecting the environment against e-waste. Always respect the current laws regarding waste material. -
Page 22: Translated Safety Warnings
Safety information Teldat S.A. B.2 Translated Safety Warnings Connections Teldat Router G1N... - Page 23 Safety information Teldat S.A. Teldat Router G1N...
Need help?
Do you have a question about the G1N and is the answer not in the manual?
Questions and answers