Table of Contents
Advertisement
Teldat S.A.
3.4.3.1 If the Ethernet cable isn't PoE
• Make sure that the router's power supply switch is in the OFF position (0).
• Ensure that the power supply is NOT connected to either the electricity or the router.
• Connect all data cables.
• Connect the power supply cable to the device.
• Connect the power supply cable to the electricity supply.
• Set the router's power supply switch to the ON position (1).
3.4.3.2 If the Ethernet cable is PoE
• Check that the Ethernet cable going to be used for power is NOT connected to the router.
• Make sure that the router's power supply switch is in the OFF position (0).
• Ensure that the power supply is NOT connected to the electricity supply.
• Connect all data cables.
• If you need redundant power, connect the power supply to the device.
• If you need redundant power, connect the power supply to the electricity supply.
• Connect the Ethernet cable.
• Set the router's power supply switch to the ON position (1).
3.4.4 Disconnect
3.4.4.1 If the Ethernet cable isn't PoE
• Make sure that the router's power supply switch is in the OFF position (0).
• Disconnect the power supply from the electricity supply.
• Disconnect the power supply from the router.
• Disconnect the data cables.
3.4.4.2 If the Ethernet cable is PoE
• Disconnect the Ethernet cable.
• Make sure that the router's power supply switch is in the OFF position (0).
• Disconnect the power supply from the electricity supply.
• Disconnect the data cables.
3.5 RST Button
The different features of the RST button are described below.
3.5.1 Rebooting the device
Once the device is operating normally, if you press the RST button, this will restart.
3.5.2 Default Configuration
The RST button allows you to boot the device with its default configuration through the following steps:
• With the device switched off, keep the RST button pressed and switch on the router through the ON/OFF switch
(1).
• The PSU LED (green) will light up and the Alert LED will begin to blink (amber). This blinking will continue for 10
seconds.
Teldat K/KF router
3 Components and Power Supply
13
Advertisement
Table of Contents
Need help?
Do you have a question about the K Seres and is the answer not in the manual?
Questions and answers