Rst Button; Rebooting The Device; Default Configuration; Data Connections - Teldat Connect-FW5G Installation Manual

Teldat S.A.
To avoid electric shocks, residual current circulation, and other unwanted effects that also affect communications, the
following is recommended:
Warning
All interconnected communication devices should be plugged into THE SAME GROUNDED POWER
OUTLET, which should, at the same time, be of good quality (lower than 10 ohms).
We recommend connecting all data devices to the same power source regardless of whether the work-
place has an uninterrupted power supply system (UPS), a regulated supply, or is independent of other
power supplies (such as lighting, etc.). This will help prevent malfunctions and premature aging of the
drivers and other components.

3.6 RST button

The different RST button features are described below.
RST button
Fig. 23:

3.6.1 Rebooting the device

Once the device is operating normally, pressing the RST button will force a restart.

3.6.2 Default configuration

The RST button allows you to boot the device with its default configuration following these steps:
• With the device switched off, keep the RESET button pressed until the device switches on.
• The SYS LED (green) will light up and the WLAN-2 LED will begin to blink. This blinking will continue for 10
seconds.
• For the device to boot with the default configuration, release the Reset button while the WLAN-2 LED is blinking
(i.e., before the 10-second period expires).
Once the default configuration is running, the router's default configuration establishes the following access IP and
mask address:
• IP address: 192.168.0.1
• IP mask: 255.255.255.0
Note
Some devices leave the factory with customized settings. This personalization means your router's de-
fault configuration (and that of the embedded access point, where applicable) may be different from the
one shown above.

3.7 Data connections

The Teldat Connect-FW5G router has the following data connections.
Teldat Connect-FW5G
3 Components and Power Supply
15