Advertisement
English
To wash fabric coverings, put them into lukewarm water with small amount of
laundry soap or your own shampoo and wash gently by hand. Rinse well with fresh
water and wipe off with a soft cloth. Dry them in the shade at ambient temperature.
WARNING :
Never use petrol, thinner, benzene or any other solvents.
To replace the fabric covering, first ensure the cover is turned right side out with the
5
6
7
EMERGENCY tab drawn through the slot (5), making sure it is not twisted. Next, stretch
the cover over pad and adjust it to lie smoothly (6). Then push the rectangular collar
through the pad assembly, making sure it is not twisted, and adjust into final position (7).
To install the cheek pad in the helmet, first slide the chinstrap through the
hole in the center of the cheek pad.
Slide the front tab on the cheek pad under the black center pad chin liner in
8
9
the front of the helmet (8), then push the rear of the pad against the shell until
it is fully home (9).
Note the white rubber stopper attached to the EPS liner where the cheek pad
10
11
meets the EPS liner. Make sure the back of the cheek pad does not get caught
on this stopper (10), and the stopper is visible and secures the rear bottom of
(11)
the cheek pad
.
Pull the chinstrap completely through the cheek pad to ensure there is no play
in the chinstrap and it is not trapped behind the cheek pad.
20
Advertisement
Chapters
