Advertisement
English
Work the shield up and down to confirm proper operation (7).
7
To replace the peak, position the peak over the side pod so that the two
8
holes are in line with the holes on the side pod (8).
Position the pressure plate with the locating pin (9) on the back of the pressure
10
11
9
plate into the corresponding hole on the rear side of the pod and the front
screw hole is in line with the helmet's front side hole on the side pod (10).
Install the screw and tighten it but do not over-tighten (11). Repeat for the
other side.
To use the helmet with just the shield, remove peak as per previous instructions.
12
Although the shield can be held in place as it is, it is recommended that the
pressure plate from the peak be attached to the side pod on each side to help
reduce possible wind noise from the open holes on the side pod (12). Do not
over-tighten the screws.
To use the helmet with just the peak, remove peak and shield as per
13
previous instructions. Without replacing the shield, install the peak with
pressure plates mounted, as per previous instructions (13).
14
Advertisement
Chapters
