Advertisement
5
12
1
2
3
4
6
English
With the peak and side pods removed, raise the shield fully (1) and remove
the shield from the base plates (2).
To replace the shield, position the shield on the base plate so that the lower
part of the sliding slot of the shield is over the tabs at the base plate's top
screw point and the brass stud of the shield is in the upper end of the sliding
slot of the base plate, marked in red (3). Repeat for the other side.
Lower the shield to the first stop, making sure the tabs at the base plate's
top screw point firmly holds the shield and the brass stud of the shield is
correctly in the sliding slot of the base plate on both sides (4).
Position and align the side pod over the base plate with the bottom and rear
edges of the side pod lined up with the base plate edges, and then, slightly
lowering the side pod will allow it into the engaged position (5). With your
thumbs placed on the 3-stripe marks on the side pod, push the side pod
upward until it is firmly engaged to the base plate (6). Repeat for the other side.
Advertisement
Chapters
