Installing The Host Registration Service For Solaris - ADIC Scalar i2000 Installation Manual

Installing the Host Registration Service for Solaris

Install this software on a host computer running the Solaris operating system that is attached to the Scalar
i2000.
You must uninstall previous versions of HRS on Solaris before installing a
Note
newer version.
To install HRS on Solaris
1 Verify that the Solaris host you are configuring has an installed Host Bus Adapter (HBA).
2 Obtain HstRegSrv.tar from your service representative.
3 From the command line type
as -A | grep hrs
and press Enter.
If a previous version of HRS is found, a message similar to the following is displayed:
<219 ?
4 If no messages similar to the output in 3 display, proceed to 6.
If a similar message displays, type
pkgrm <package name>
and press Enter.
5 If you removed a package, reboot the host:
reboot -- -r
6 Find the HstRegSrv.tar file.
7 Copy HstRegSrv.tar to a temporary directory.
8 From the directory that has HstRegSrv.tar in it, type:
tar xf HstRegSrv.tar
and press Enter.
9 Type the following command:
pkgadd -d .
and press Enter.
10 Type the following command:
reboot -- -r
and press Enter.
HRS runs when the system is booting. The file that controls this process is S99hrs and it can be found
in the folder /etc/rc2.d
The default re-registration period is 5 minutes.
To change the re-registration period
1 Find the PID for the current HRS process. Type
ps -ef | grep hrs
Scalar i2000 Installation Guide
0:00 hrs>
91