Table of Contents
Advertisement
5.5.
CONFIGURING THE OUTPUT VIDEO SETTINGS
The Output Video Settings menus are used to configure parameters associated with the output video
processing functions. The chart below shows the items available in the Video menu. The following
sections provide detailed information about each of the parameters.
Loss of video
525 H phase
625 H phase
525 V phase
625 V phase
5.5.1. Selects the Action to Take when Input Video is Missing
Video Path 1
Output Video Settings
Loss of video
Freeze
Black
5.5.2. Setting the Horizontal Phase of the Output Video – NTSC/525 Video
Video Path 1
Output Video Settings
525 H phase
0 to 1715
0
5.5.3. Setting the Horizontal Phase of the Output Video – PAL-B/625 Video
Video Path 1
Output Video Settings
625 H phase
0 to 1727
0
Selects the action to take when the input video is missing.
Sets the horizontal phase of the output signal to a NTSC Genlock
reference input.
Sets the horizontal phase of the output signal to a PAL Genlock
reference input.
Sets the vertical phase of the output signal to a NTSC Genlock
reference input.
Sets the vertical phase of the output signal to a PAL Genlock
reference input.
The user can either have the output video go to black, or freeze the
last good video picture at the input with this control.
With this control, you can set the horizontal timing of the output video
with respect to the Genlock reference input when operating in
NTSC/525 video mode. Setting this control to 0, keeps the monitoring
output video in time with the Genlock reference. The SDI output will
be a couple of microseconds advanced to the Genlock reference.
Increasing the value will delay the output video in one-sample
increments.
With this control, you can set the horizontal timing of the output video
with respect to the Genlock reference input when operating in
PAL/625 video mode. Setting this control to 0, keeps the monitoring
output video in time with the Genlock reference. The SDI output will
be a couple of microseconds advanced to the Genlock reference.
Increasing the value will delay the output video in one-sample
increments.
Revision 1.0
7800 MultiFrame Manual
7737/7837CD2 Dual Composite Decoder
Page - 15
Advertisement
Table of Contents
