Table of Contents
Advertisement
6.5.
CONFIGURING THE VIDEO PROCESSING FUNCTIONS
The Proc Functions menu is used to configure parameters associated with the video processing functions
of the down converter. The chart below shows the items available in the Proc Functions menu. Sections
6.5.1 to 6.5.12 give detailed information about each of the menu items.
ALL of these parameters affect the video in real time. H&V frequency bands will
cause hits to the video while a new filter is loaded.
Image Enhancement
RGB Clip
Gamma Adjust
Y Gain
Y Offset
Cr Gain
Cr Offset
Cb Gain
Cb Offset
Hue
R Gain
G Gain
B Gain
Gamma Level
Luma Floor
Detail Noise Floor
Enhancement Limit
Horizontal Band
Controls all Image Enhancement Adjustments.
Controls RGB Clipping.
Controls all Gamma Adjustments.
Sets the Source Y Gain.
Sets the Source Y Offset.
Sets the Source Cr Gain.
Sets the Source Cr Offset.
Sets the Source Cb Gain.
Sets the Source Cb Offset.
+/- 10 degrees 0.1 degree steps.
Sets the Gain in RGB Domain.
Sets the Gain in RGB Domain.
Sets the Gain in RGB Domain.
Sets the gamma correction factor.
Sets the darkest luma value that will be enhanced.
Sets the minimum level of detail required before the enhancer is enabled.
Sets the maximum enhancement allowed.
Sets the horizontal frequency band.
Revision 1.1
7700 MultiFrame Manual
7714HDC High Quality Down Converter
7714HDC - 23
Advertisement
Table of Contents
