Table of Contents
Advertisement
What to Do Next
for Member
Switches
After configuring a member switch, do the following:
1. Power off the member switch by disconnecting its AC power cord from
the AC power source. Refer to Figure 74 on page 140.
2. Repeat these procedures to configure all member switches, assigning
each one a unique ID number and designating the Multi-Gigabit copper
ports as the stack trunk.
3. If you have not already configured the master switch, perform
"Configuring the Master Switch" on page 133.
4. Power off the master and all member switches.
5. Cable the Multi-Gigabit copper ports on the master and member
switches. For trunk cabling examples, refer to "Multi-Gigabit Copper
Ports" on page 49. Refer to "Cabling Copper Ports" on page 150.
6. Perform "Powering On the Stack" on page 148.
7. Perform "Verifying the Stack and Assigning Priority Numbers" on
page 123 to confirm that the switches formed the stack.
8. Cable the networking ports, as explained in Chapter 11, "Cabling
Copper and SFP+ Ports" on page 149.
x330 Series Installation Guide for Virtual Chassis Stacking
147
Advertisement
Table of Contents
