Table of Contents
Advertisement
Chapter 8: Displaying the Hardware Status and AlliedWare Plus Version Number
114
Note
The baud rate must be set to the default 9600 bps to configure the
boot loader.
4. Press Enter. You are prompted for the name and password of the
manager account.
5. Enter the default user name "manager" and password "friend", without
the quotes.
Note
User names and passwords are case sensitive.
The switch starts the local management session and displays the
following prompt:
awplus>
The prompt is the User Exec mode in the command line interface of
the AlliedWare Plus management software. For instructions, refer to
the Software Reference for x330 Series Switches, AlliedWare Plus
Operating System.
6. Do one of the following:
To view the hardware status of the switch and AlliedWare Plus
version number, go to "Displaying the Hardware Status and
AlliedWare Plus Version Number" on page 115.
To configure the switch for stacking, go to Chapter 9, "Building
Stacks with SFP+ Ports S1 and S2" on page 117 or Chapter 10,
"Building Stacks with Multi-Gigabit Copper Ports" on page 127.
Advertisement
Table of Contents
