Installing The Switch - Allied Telesis x330-52GTX Installation Manual

Installing the Switch

This section contains the procedure for installing the switch on a wall.
Review the following before performing the procedure:
If you are installing the switch on a wall with wooden studs, the

procedure assumes the plywood base is already mounted on the
wall.
Review "Reviewing Safety Precautions" on page 66 and "Choosing

a Site for the Switch" on page 70 before performing this procedure.
Allied Telesis recommends a minimum of two people for this

procedure.
Warning
The device is heavy. Always ask for assistance before moving or
lifting it to avoid injuring yourself or damaging the equipment.
Warning
The device should be installed on the wall by a qualified building
contractor. Serious injury to yourself or others or damage to the
equipment may result if it is improperly fastened to the wall.  E105
To install the switch on the wall, perform the following procedure:
1. Place the switch on a table.
Note
If the bumper feet are attached to the bottom on the switch, remove
them before continuing.
2. For x330-20GTX and x330-28GTX Switches, attach the four AT-
BRKT-J24 wall brackets to the sides of the switch, with the sixteen
M4x6mm screws included in the brackets kit. Refer to Figure 55 on
page 106.
x330 Series Installation Guide for Virtual Chassis Stacking
105