Chapter 7: Installing x330-20GTX, x330-28GTX, and x330-52GTX Switches on a Wall
102
Here are the required tools and material for installing the switch on a wall:
For x330-20GTX and x330-28GTX Switches, one AT-BRKT-J24
wall brackets kit for each switch. The kit is sold separately.
For the x330-52GTX Switch, the two wall//equipment rack brackets
are included with the device.
Four wall anchors and screws (not provided) The diameter of the
screw holes in the brackets is 5mm.
Cross-head screwdriver (not provided).
Stud finder for a wooden wall, capable of identifying the middle of
wall studs and hot electrical wiring (not provided).
Drill and 1/4-inch carbide drill bit for a concrete wall (not provided).
Plywood base if you are installing the switch on a wall with wooden
studs (not provided.) Refer to "Plywood Base for a Wall with
Wooden Studs" on page 103 for illustrations.
Four screws for attaching the plywood base to the wall (not
provided).